Subject: Mike Wills inspired Glastar Mount
From: Paul
Date: 3/19/2001, 8:09 AM

Perry Casson wrote:

Attached are a couple photo's of my Mike Wills inspired mount for a Glastar.
I have not done the final welding yet but I think it should be solid enough
(comments more that welcome).  I guess my next plane will have to use
Paul/Leon's cast housing...

All Tubes 3/4 x 0.049 4130
Front Brackets 1/8 4130
Rear Brackets 0.5" 60601

Perry Casson

Perry, like I told Mike you need some up and down bracing on the rear mounts.
The front mount configuration is fine if not a bit space consuming vis a vis
the rad under the engine trick and the cross tube. A lot like my C182 BTW.

More about this (and your pictures) when I get a bit more time. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry Casson-mm7.jpg