I am doing this manifold first as it is not practical to use a bent tube
manifold with the stock turbo. Its too tight of a package. Bent tube
manifolds work fine on a NA six port however. This is very similar if
not identical to the stock turbo manifold except it is much lower
.... SNIP
. Long tubes
are bonded or tig welded into the sockets on this manifold. They are
spaced to clear the oil filler neck on the other side of the engine. I
considered making it out of fiberglass but the close proximity of the
hot turbo ruled that out.
If you have any suggestions I need to hear them now.
Paul Lamar
Ed Anderson wrote:
Great looking runners, Paul!
I presume that its is intended that the injectors will be incorporated
into the upper part of the manifold that the buyer of the lower part would
fabricate . Also, am I correct in assuming from the dimensions and
curvature that the tubes will be too close to the block to use the block
injector ports. I like the idea of keeping it as close to the block as
possible as that would appear to make it adaptable to just about any
configuration and of course the injectors can be placed just about anywhere.
Any ball park figures on what the cost may run in US $$? I know it will
depend on quantity, but lets say for a run of 10 to being with. I do want
to unload this boat anchor of a lower manifold I have been flying with.
Ed Anderson
There is quite a bit of evidence out there that slightly better fuel consumption
is had by putting the injectors at the start of the tubes.
Not yet. Leon needs to get the patterns and get some bids from Sydney foundries.
I have my fingers crossed that high density 3D milled foam patterns and core boxes
will be acceptable. It should not be much however due to its very small size
and simplicity.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org