Subject: Design & Weight of Bell Housing dimensions
From: Paul
Date: 3/20/2001, 12:55 PM

Tracy Crook wrote:

For Paul, Leon & others doing their own redrive adapters, the diameter of
the bolt circle is 5.875".  The pattern is 12 holes (1/4" diameter, 30
degrees apart) with the top two holes 15 degrees either side of the 12:00
position.   The center hole for the input shaft is 1.010" .  The counter
bore for the input shaft oil seal is 1.500" dia. and depth is .310, bored
from the engine side.   Starter hole is 2.675" in diameter and center to
center didtance (from input shaft hole) is 6.700".  Put this hole in any
position you like as long as these parameters are met.   It is difficult to
specify the 2 starter mounting bolt holes because it depends on starter
position & orientation.  I would suggest just putting the starter in the
hole and marking the mount holes for hand drilling.  They are not that
critical.

I don't want to get into the starter position debate but I've attached two
photos taken during Ed's recent trip showing where he positioned his heat
exchangers.  You can't actually see the starter in these pics but it is in
the 6:00 position.  Looks out of the way to me.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

Ed sure does nice work. Thanks Tracy.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ed-Anderson-Edsengine.jpg

Ed-anderson-Edsinlets.JPG