Subject: Design & Weight of Bell Housing dimensions
From: Paul
Date: 3/20/2001, 3:44 PM

Ed Anderson wrote:

 Thanks, Paul, Tracy

   I have attached an old photo that shows the starter position.   Looking
at the front view, the starter is position behind the spinner below the Ross
Drive.  A AN-6 hose runs under the starter about 3" and connects the bottom
of the  two evaporator cores.

    Have you ever seen so many cooling fins?

Ed

The problem with this layout is it won't work with a turbo.
The turbo will heat the back side of the left rad. With one rad on the
bottom and a left side exhaust both turbo and tangential mufflers are
easily accommodated on the left side of the up right engine in the cowling.
Also one rad will be more efficient than two rads in series as  shown here.
Simplicity is a virtue.

I won't go into the myriad cooling and oil system drawbacks of the plugs up 
engine shown in this picture again unless I am forced to. If God and the Mazda
engineers wanted to mount it that way they would have done it in the RX7.

We have been all over this in the past many times in the past.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ed-Anderson-Starter_Position.jpg