Subject: Design & Weight of Bell Housing was RE: Cast bell housing Take 3
From: Paul
Date: 3/20/2001, 4:38 PM

Leon Promet wrote:

Hi Paul,

I KNOW what we said, so we put the starter on the plug side, up high enough
to clear the plane from the pan to the redrive.  OK,  so I must be going
sane!  The direction of drive,  (tractor or pusher) doesn't affect this.

With the sump down, (normal orientation), the starter should be on the plug
side.  Correct??  Your drawing shows it on the exhaust side.

It is an old obsolete drawing. Put the starter on the plug side next to the redrive
and not next to the engine. Keep it lower than the top of the engine
so it will clear a low cowl. PL


I don't CARE which side it actually goes on,  I'm dong this for you guys,
and I'll do my own thing as well,  but I just want to make ABSOLUTELY sure
that I am giving you what you want.  We have to get this right first go,
 otherwise we get to do it all over again a second time and it will cost
twice as much,  take 5 times as long,  and just give everybody, ( including
me) a severe case of the shits!

Please find attached BELLHOUS.GIF you sent me,  which clearly shows the
starter on the EXHAUST side of the engine. (I have already given this to
Jeff).  The exhaust side is the one where the two bolts at the top are c
lose together,  and there are none down the side!!  The end elevation is
shown looking at the back side (flywheel end) of the engine,  towards the
front.  Please correct me if I'm wrong.

The Bill Schertz gif shows the end elevation looking the other way, looking
from the water pump end,  and has the starter on the plug side.  Can't
identify what holes 5 and 7 are for.

I'd also appreciate if you could double check the dimensions of the
Tracey-redrive-2-d gif as well. (Yes I understand that this is for a "Plugs
Up" orientation, and the starter is actually underneath the engine) but I'm
just looking at the bolt holes for the redrive.  I don't want to be making
things and find that somebody has cocked up!

So can I ask you and Tracey to please TRIPLE check all measurements before
I start making Swiss Cheese out of expensive castings.

Cheers,

Leon Promet
peon@pacific.net.au


Here is what Tracy said and I can confirm these dimensions as I have one of
his redrives. Ignore those drawings I sent you Leon. This is what counts.

"For Paul, Leon & others doing their own redrive adapters, the diameter of
the bolt circle is 5.875".  The pattern is 12 holes (1/4" diameter, 30
degrees apart) with the top two holes 15 degrees either side of the 12:00
position.   The center hole for the input shaft is 1.010" .  The counter
bore for the input shaft oil seal is 1.500" dia. and depth is .310, bored
from the engine side.   Starter hole is 2.675" in diameter and center to
center distance (from input shaft hole) is 6.700"."

Tracy, we need one more dimension and that is the overall OD of the redrive
so Leon can put a locating recess in his bell housing. Sort of a large counter
bore. I figure it to be about 6 and 9/16th OD but we need the actual dimension
down to the nearest .001 inch.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org