Todd Carrico wrote:
Paul Lamar:
Very simple Leon. It becomes redundant to specify tolerances as
modern NC mills are what they are.
You put in .1874 in the NC program and that is what you get to the
best of the NC mills ability. Usually .0005.
Todd Carrico:
<QA>
That is probably an over simplification. Lots of things go into the
finished part, such as rigidity of the fixture holding the part, tool wear,
tool offsets (to compensate for tool wear), Multi-step operations where you
have to remove the part and reposition it. Just because the machine is
capable of moving a tool to within .00005 of where you want it, doesn't mean
that your part will have that kind of accuracy. Murphy has a lot to do with
it.
</QA>
I think that properly thought out dimensions add a professional touch. If
you are worried about how much time it takes, you can specify a general
standard (say +/- .010) and then for special areas specify a tighter
tolerance. This will give the machinest some flexability in how they
fixture the part. It also gives you some leverage if they can't make a part
that is suitable.
tc
This is not rocket science we are doing here guys. There is a certain amount of
flexibility in the input shaft in the form of two splines and a pilot hole
that may vary in size depending on how the old needle bearings were removed. At least
I think the pilot hole is used. I forgot for sure. Tracy do you use the
pilot hole in the end of the e-shaft? If not the pilot hole..... the
input shaft end is located by four RUBBER bushings!
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org