and mounts the starter trailing
towards the firewall.
I don't understand this completely, but I see a direction of rotation
problem
developing here. You can't move the starter from the psru side to the
engine side and use the same starter. It will turn backwards, bendex and
all.
Bob Darrah
That is true Bob with the early starter but obviously the late
3rd gen starter is opposite rotation. IMHO the big problem is: this starter
is extremely rare due to the very small numbers of 3rd gen RX7
sold in the states. For that reason 3rd gen engines are very expensive
and so too are the starters. I don't know of anyone planning to get
400 HP out of their turbo 13B installed in an aircraft where they
might need the subtle structural improvements in the 3rd gen 13B-REW.
Leon mentioned only 350 HP in his airplane.
Besides all that the REW dual sequential turbo's
crack and are ill suited to use in an aircraft anyway.
Given that it makes no sense to cast up a 3rd gen starter bell housing
that will fit Tracy's redrive for such a small market but of course Leon is
free to do it if he chooses.
Paul Lamar
Leon Promet wrote:
Hey Guys,
A variety of different starters can be fitted, and provision can be made
to have them plunge from the engine side (remember the Rotary Pick Ups??)
as well as the PSRU side. You are correct that the direction of rotation
determines from which side of the ring gear the bendix has to plunge. All
is possible. The starter mount is very easy to incorporate into the
pattern.
For that matter, I could adapt a lightweight race Tilton Chev V8 starter
for that matter, as long as the teeth were correct and matched the ring
gear. Simply changing the ring gear on the flywheel'driveplate solves that
problem. All depends on the amount of bux a client has. If someone is on
a budget, they use the standard Mazda Stuff.
I'm looking into using a geared starter from one of a number of piston
engines that are readily available and can be sourced as new units, and
are readily available as exchange units etc. The ideal thing is to have
the starter plunge from the engine side, as it helps in the balancing act,
and completetly solves the clearance problems.
All I have to do is find a suitable starter, which is readily available,
at a reasonable cost, and I will supply it as an optional extra. The
mount can be incorporated in the housing and just blocked off if the
conventional Mazda starter is used.
I am currently researching all this, and will come up with a range of
solutions. I will be using a geared starter, plunging from the engine
side for my own application. Lets just get to first base using strandard
Mazda starters and flex plates first!
Cheers,
Leon Promet
peon@pacific.net.au
I believe the stock Mazda starter has a built in planetary gear reduction
and most of us get them when we get the engine. Focus Leon :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org