Hi Leon,
I agree with you on the exhaust side concerns. I am wondering if the new
casting will make the whole package shorter (for CG reasons), as light as
possible without compromising strength, and mounts the starter trailing
towards the firewall.
Paul,
is making this part out of composites viable, and could we save any weight
in the process?
Chris
microcosman.com
Shorter is not possible when using Tracy's stock redrive input shaft.
Sure almost anything is possible with composites. I don't think the heat would
be a big issue. I think Bill Freeman would worry about losing the engine in
the event of a in-flight fire. That to me sounds like it rules it out.
Bill is already concerned with aluminum motor mounts melting with an
in-flight fire.
Paul Lamar
Bill Freeman wrote:
I don't worry too much abou the massive cast mounts, .5" plates and bell
housings since they are capable of dissipating a great deal of heat. It is
the thin monocoque structures that seem risky in the event of a relatively
minor engine fire. A bunch of folded and riveted "OH-TOO-THIN" aluminum
sheet for a
motor mount seems excessively risky to me. A steel tube truss is light,
efficient, has probably better maintenance access, fails gracefully under
extreme overload, and is fire resistant.
Bill
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org