Subject: third Gen auto starter bellhousing for Tracy redrive?
From: Paul
Date: 3/20/2001, 4:06 PM


marc wiese wrote:

I will try and send only one .jpg this time (large picture file-700kb+).
The hand sketches I would make would duplicate the layout on a 1993 and on
automatic tranny rx7. I will make some anyway (by hand). Send me your
address, I will send pictures as well as sketches.

The automatic transmission gear reduced starter on these late models has
the solenoid sticking out at about 90 degrees. It mounts via an integral
casting which is part of the starter assy to both the rear engine housing,
and to the bellhousing on the plug side-down low. It straddles the two. Are
you familiar with this setup? I DO have the bellhousing, and if worse comes
to worse can ship it to you to use for this version as a pattern if you
can't find one locally (as long as I get it back)!
Marc Wiese

Bulent Aliev wrote:

My Cosmo 13B has the identical set up. I have made the adapter plate
already.
Bulent

Bulent if the distance from the joint between rear housing and the bell housing
to this adapter plate is not 3.55 inches Tracy's input shaft will not work. 
Judging from the picture this is not the case.

Is Tracy building a custom input shaft for you?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Bulent-Adapter2.jpg