I am not going to put a bigger compressor on mine until I test it as is.
I don't think we need more boost.
If they can put an Inconel TO3 turbine in there than maybe that would be
worth it.
BTW the manifold flange bolt pattern is not stock TO4 or TO3. Too bad.
Paul Lamar
The idea behind a bigger compressor is not to create more boost, but to make
a small amount of boost more easily. You have said that the biggest concern
is overspeed at altitude. A larger compressor will turn more slowly to make
a given amount of boost - thus diminishing the likelihood of overspeed.
Remember that the stock turbo is mapped to provide (primarily) low end
torque. But we will be running it at its high end where it will be working
much harder to keep up with the air flow. Take it to altitude and the
problem gets worse. The solution to overspeed (although we don't know that
it will really be a problem) is a bigger, more capable turbocharger and not
necessarily a bigger waste gate.
That being said, I'm still installing the thing stock because I am a cheap
skate and I know of no evidence which says the stock '91 won't work... one
of us is going to get to learn from the other. :-)
I don't know if they can install an Inconel TO3 turbine or not, never hurts to call.
Dave Leonard
I could be wrong but there is usually no free lunch. If you need just as
much HP out of the turbine to generate the same amount of boost it sees
the same amount of heat more or less.
I think you are trading turbine torque for turbine RPM to get the same
HP to generate the same boost. The blades stay in contact longer with
the hot exhaust pulses. At least this is the way I look at it.
Perhaps RPM will be lower and the m*V^2/r load on the turbine blades
more favorable.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org