Subject: Design & Weight of Bell Housing was RE: Cast bell housing Take 3
From: Paul
Date: 3/21/2001, 6:15 PM


Leon Promet wrote:
OK, I'm not trying to be difficult,  but as soon as I give this to a
machinist,  first thing he is going to ask me is "What is the tolerance on
the PCD? 1 thou,  5 thou.  10 thou?"  (Remember,  I worked next door to a
gear cutter for 10 years,  so I got to know how they think!!).
##
Further,  what are the hole size tolerances,  especially seeing that
without a machined register,  that's all that aligns the PSRU to the
eccentric shaft.  Are the holes and the bolts size for size,  interference
fit,  clearance holes.  what bolts are specified?  What shank size.  OK,
 they are nominal 1/4 inch,  but is that 0.2500,  0.2490,  0.2495  or what?
Leon

Its only obsolete Leon in the position of the starter.
No can of worms. The drawings are fine. Its very simple.
12.... 1/4 inch bolts on a 5.875 bolt circle.
Can you get 1/4 inch aircraft bolts down there?
Paul Lamar

Blake Mantel wrote:

GACK!!!
Paul,
You gotta give a tolerance (even if it doesn't matter)!
If you want to piss em off ->  give a wide size tolerance and then a tight true
position and concentricity tolerance.

Machinists: Love/hate relationships!

Blake

Well I think we got that settled. Tracy (God) said plus minus 0.001"!!!! 
Silence from Oz so far ROFL.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org