Leon Promet wrote:
Hi Paul,
Thanks!
I think you are making more out of this than necessary Leon. With twelve
bolts things tend to average out even if the holes are oversize.
Maybe, but I can't countenance this approach to engineering. That's why
I suggested the register be incorporated to make SURE of concentricity.
The actual bolt holes can then be clearance holes.
Additionally, we are attempting to get two engineers on opposite sides of
the world to machine things to the same size, and one has to fit inside
another.. If I can't have a definite size with tolerances so that I can
make a (go/no) gauge piece to check for correct fit, then if I have a
sample, and what I make fits the sample, then I have done my bit.
Never the less I will ask Tracy.
Tracy, what tolerances do you use? Will you ship the mating part in
question to Leon?
Paul Lamar
OK here are the tolerances based on a few rough calcs. +/- .1 degree
on the bolt locations. +/- .001 on the bolt circle dia.
-.0000 +.015 on the bolt holes themselves and -.000 + .005 on the seal bore.
The 1.010 shaft clearance hole is -.0000 +.015
BTW I looked at the manual bell housing today and the stock starter position
you now have on this bell housing is fine. I think the solenoid sticks
up from here.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org