Jerry, in previous letter you statue, you have an kit for $200
whcich
include ...? And this kit could do ....... ?
I do not look on way how need to measure max. current when
flaps is overloaded. What I need is find a source to buy good
quality
servos with or without electronics/electromechanics.
Please describe what you kit do and where I could get what is not
included in the kit.
Thanks.
Vlad
N1UT - Velocity Elite, RG, Mazda 20B rotary, NA - engine
installation in
progress
http://www.N1UT.velocity-air.com
"Bass, Jerry" wrote:
The kit includes a PC board that should be located near the flap
actuator. A
control to be mounted on the instrument panel or someplace convenient.
A
feedback device that must be connected to the flap lever. Mine is near
the
actuator screw.
You need to provide a +12 v dc ground, and wiring between the actuator
and
the PC board and drive motor.
Jerry Bass
It is better!
But still I ask you where I could look on specs and pictures.
Who is manufacturing actuator and board? Where I could purchase one?
Thanks.
Vlad
"Bass, Jerry" wrote:
I have designed a servo that has the electronics, actuator and a bit of
hardware, not the screw or mechanical connections. If you have the
mechanical apparatus set up in you plane, you can use jumpers and a Amp
meter to record the current and a battery.
My unit has a control you mount on your instrument pnl and hook the three
wires to the servo drive.
the servo drive mounts near the mechanical actuator and uses a feedback
pushrod to follow the mechanical arm.
one of the other e-mails today has a screw push/pull for $160.
Jerry Bass
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org