Subject: 88 verses 91 turbo.
From: Paul
Date: 3/23/2001, 1:06 PM


 > The idea behind a bigger compressor is not to create more boost, but to
make
 > a small amount of boost more easily.  You have said that the biggest
concern
 > is overspeed at altitude.  A larger compressor will turn more slowly to
make
 > a given amount of boost - thus diminishing the likelihood of overspeed.
 > Remember that the stock turbo is mapped to provide (primarily) low end
 > torque.  But we will be running it at its high end where it will be
working
 > much harder to keep up with the air flow.  Take it to altitude and the
 > problem gets worse.  The solution to overspeed (although we don't know
that
 > it will really be a problem) is a bigger, more capable turbocharger and
not
 > necessarily a bigger waste gate.
 >
 > That being said, I'm still installing the thing stock because I am a
cheap
 > skate and I know of no evidence which says the stock '91 won't work...
one
 > of us is going to get to learn from the other.  :-)
 >
 > I don't know if they can install an Inconel TO3 turbine or not, never
hurts to call.
 >
 > Dave Leonard

 I could be wrong but there is usually no free lunch. If you need just as
 much HP out of the turbine to generate the same amount of boost it sees
 the same amount of heat more or less.

 I think you are trading turbine torque for turbine RPM to get the same
 HP to generate the same boost. The blades stay in contact longer with
 the hot exhaust pulses. At least this is the way I look at it.

 Perhaps RPM will be lower and the m*V^2/r load on the turbine blades
 more favorable.

 Paul Lamar


I would agree with everything you say here.  Yes, this would be trading RPM
for relatively higher torque, and relatively longer blade time in the hot
exhaust pulses.  However, that is relative to the overspeeding condition.
Remember that the reason overspeed becomes a problem at altitude is because
the thinner ambient air is providing less resistance (torque).  Similarly,
the slower RPM is only relative to the overspeed condition and the actual RPM
will hopefully be in the normal range (with normal blade/hot-pulse exposure).


Opening the waste-gate is no doubt a perfectly safe way to solve the
overspeed problem as well, as long as you had a properly regulated waste-gate
controller (manual or otherwise which diminishes boost at altitude).  How
much boost will be left for the engine?

But now, its off to cut my canopy  :-)  yikes

Dave Leonard

I agree with this Dave. I am not sure it is a real problem yet.
I need to take some turbine RPM data before I am convinced it is a problem.
I am trying to keep cost down the same as you.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org