Leon Promet wrote:
Hi Mark,
In a word, NO. The problem is with porosity of the casting. Can't be done
reliably with a sand casting. Only with a pressure die casting. Quality
control would be nightmare! There are going to be LOTS of reject castings
as it is with casting flaws.
It would be far cheaper to use a properly double flared steel line, or a
steel reinforced braided hose using hydraulic fittings. They should never
fail, as long as it's suitably supported so it can't vibrate and suffer
fatigue. Certain items like this should be pressure tested before fitting,
given a VERY conservative service life, especially hoses, and be junked
at regular intervals.
Mazda did have such an animal in their early Cosmo manuals. They had a
fluid coupling between the engine & the G'box.
BUT, and this is important, ... the oil pressure feed was taken from the
rear of the eccentric shaft. That model had a removable threaded plug for
just such purposes instead of a brass bung.
The oil dump WAS cast into the housing, but of course, the dump side
wasn't under pressure, and the housings WERE pressure die cast.
Mate I'm afraid not. Not practical from my point of view, and not cost
effective. The only reason people have problems with external hose or
pipe is that they don't use the correct stuff, or don't have the necessary
skills to be doing it anyway.
Cheers,
Leon Promet
peon@pacific.net.au
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org