Subject: Design & Weight of Bell Housing was RE: Cast bell housing Take 3
From: Paul
Date: 3/23/2001, 1:37 PM

Leon Promet wrote:

Hi Tracey,

I got the dimensions and the tolerances from Paul.  Thanks.


I am not the final say Leon. Tracy is!!! Use his tolerances. PL


SNIP >>

On the diameter of the planet carrier housing, It is nominally 6.75", but
this is not a tightly controlled dimension since it is non critical and
every tight tolerance specified adds cost.  The exact OD has been
different
on each batch of planet carrier housings.

Why??  I know,  didn't specify a dimension and a tolerance??

 If the outside is not a precise dimension,  what about the inside?
 Otherwise,  I'll just drill the holes as per the specs, and hope it fits.
 I really need a sample.  As I said to Paul,  you might think I am being an
"old woman",  but I have had VAST experiences of machinists and engineers
who make mistakes.  I don't really care if they make them,  as long as they
pay for them,  and eventually get it right!  I only pay for RIGHT jobs.
 How do I know if it is RIGHT unless I have a gauge??

   Sorry.  If someone wants to turn
the housing down to a tightly specified dimension, be my guest.  The 12
holes ARE perfectly concentric (+ or - .001") with the housing OD
however.
This being the case, sending this part to Leon would not serve any real
purpose.

SNIP >>

By all means, EXPERIMENT!  Just remember Det. Callahan's words of wisdom.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 > 
##
Sorry,  forgive my ignorance?  What did he say??  Should I add this to my
quote book??


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org