Subject: Leon's questions on Bell Housing Take xxx
From: Paul
Date: 3/23/2001, 11:29 PM


 If the outside is not a precise dimension,  what about the inside?
 Otherwise,  I'll just drill the holes as per the specs, and hope it
fits.
 I really need a sample.  As I said to Paul,  you might think I am being
an
"old woman",  but I have had VAST experiences of machinists and
engineers
who make mistakes.  I don't really care if they make them,  as long as
they
pay for them,  and eventually get it right!  I only pay for RIGHT jobs.
 How do I know if it is RIGHT unless I have a gauge??
Leon


Tracy Crook wrote:

Tracy Crook wrote:

Think I missed some interim messages.

I will gladly furnish the data requested but I am hesitant to get actively
involved because I know the possible complications.  Anyway, here is what I
can do on the planet carrier OD situation.  For those using Leon's
bellhousing, I can furnish this part with a known OD of  6.615" + or - .001"
but builders MUST specify this when ordering.

If you want to locate on the ID of the part (which is tightly controlled) ,
there are two different models to consider, RD-1A is 4.945" and RD-1B is
4.967"  (both + or - .001) .  As I said, I'm happy to supply dimensions,
tollerances, etc, but if they do not suit what you are doing I am unable to
offer a solution.  The OD has been variable because I do not locate anything
on it in my design.   See above offer on the OD for possible solution.



By all means, EXPERIMENT!  Just remember Det. Callahan's words of
wisdom.

Tracy Crook

Leon wrote:

Sorry,  forgive my ignorance?  What did he say??  Should I add this to
my
quote book??

It was a reference to a previous message addressed to all builders of
experimental aircraft
where I quoted the fictional character Det. Callahan also known as "Dirty
Harry".  The quote was "A man's got to know his own limitations".  Up to you
whether to add it to your book or not.  I've found it to be useful advice
though.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org