Subject: Oil pressure and Bearings
From: Paul
Date: 3/23/2001, 6:13 PM


Martin G Yates/STA/Lotus wrote:

Hi guys

I am of the belief that too much oil pressure can harm your bearings by
washing away the bearing material.

Please can someone confirm/deny this.

Basically, on the 2nd Gen list, there's an RX7 owner who's oil pressure is
running at about 110 (on 2 different guages ) above 3000 rpm. Someone said
it can do no harm, except drain away some horsepower.

thanks

Martin Yates
Education Specialist
Lotus Park, The Causeway, Staines, Middlesex, UK. TW18 3AG
email : martin_g_yates@lotus.com
Office tel no: 44 1784 445-424  Fax no: 44 1784 445-580 or 44 1784 499-424


Bill Freeman wrote:

The bearings will be fine.   The actual pressure under the
bearing where the oil wedge builds up is likely to be at least
several hundred psi.  I would only worry about the possiblity
of overloading the oil cooler and lines, etc with pressures higher
than necessary.  There is no reason in the world to have excessively
high oil pressure, it helps nothing.  The oil system is pumping
an essentially incompressible fluid with a constant volume pump.
At near zero oil pressure (obtained by VERY loose brgs) it is
pumping the same volume of oil, which is all the bearings care
about - a) enough oil to sustain the oil wedge to keep the surfaces
apart and b) enough flow rate to cool the bearings which generate quite
a bit of heat due to shearing in the oil.   Lower the pressure with
the pressure relief valve (I assume these things do have a pressure
relief valve, essentially all cars do), assuming it is accessible and
adjustable by either cutting or shimming the spring.  Typically, too
high a pressure is from to strong or too tightly shimmed a spring on
a pressure relief valve and does not improve much.

The only possible scenario where increasing the pressure relief level
would "help" is to force some more oil thru the bearings instead of
relieving it in the bypass.  This seems of no value since this would
only be due to very tight bearings passing a lower oil flow than the
pump MUST pass, so the excess (designed in) is bypassed.  Forcing
more oil thru good, tight bearings is of no real benefit.  If the bearings
are loose, they will flow more oil, a good thing, and less flow rate
will be bypassed to maintain the relief pressure.  Oil pressure only
falls when the oil consumers loosen up enough to take all the flow
when the bypass (relief) valve is fully closed.   This happens in an
old, worn motor - but is not what is going on here.

Bill

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org