Subject: Oil pressure and Bearings
From: Paul
Date: 3/23/2001, 6:58 PM


<< Martin G Yates/STA/Lotus wrote:
 >
 > Hi guys
 >
 > I am of the belief that too much oil pressure can harm your bearings by
 > washing away the bearing material.
 >
 > Please can someone confirm/deny this.
 >
 > Basically, on the 2nd Gen list, there's an RX7 owner who's oil pressure is
 > running at about 110 (on 2 different guages ) above 3000 rpm. Someone said
 > it can do no harm, except drain away some horsepower.
 >
 > thanks
 >
 > Martin Yates
 > Education Specialist
 > Lotus Park, The Causeway, Staines, Middlesex, UK. TW18 3AG
 > email : martin_g_yates@lotus.com
 > Office tel no: 44 1784 445-424  Fax no: 44 1784 445-580 or 44 1784 499-424

  >>
It is a big load on the stock oil pump and chain. I would like to get that
much oil pressure even with a Peterson dry sump pump. The best I can get, is
100 PSI at full tilt. We run more clearance on both mains and rotor bearings.
I have never heard of damage from high oil pressure. I can get higher
pressure by turning the pump faster, and there are some who run over 110 PSI,
but I have not lost one from that problem (yet). Most of the hop up books
suggest 110 to 115 pounds for racing. I don't think it's any problem at all.
Lynn E. Hanover GT3 number 85.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org