Ed Anderson wrote: (On 1-21-2001 <CD> )
Chuck,
My 13B powered RV-6A with the 6 port gave me a top speed of 186 MPH
TAS
(GPS Verified) . I initially estimated my HP to be in the 160 HP range.
I
then did a very careful measurement of my fuel burn. By flying WOT off
one
tank for 30 minutes using the other tank for take-off and landing. The
resulting fuel burn was 10.57 gallons/per hour. I was pretty pleased with
the great mileage until I realized it was the results of low HP. This
works
out to approx 114 HP for the rotary at 8000 MSL. This translates in to a
sea level HP of approx 152 HP. This was with the engine in its peak
condition.
Later due to the faulty installation of an apex seal with overtime caused
sufficient scoring of the side walls to drop performance, the HP had
decreased due to the damage to around 130Hp before I stopped flying it and
changed engines. By this time the top speed had dropped to the 170 MPH
range. While in the air it was not that bad, mainly climb was slow and of
course top speed was down, but it was still 40 mph greater than the Pipes
and Cessnas I was use to flying.. However, where I really notice the lack
of HP was take off on hot days on short runways. Make for Looonggg take
off
rolls and ROC had fallen to less than 1000 fpm.
If you really want to get a fairly accurate measure of your HP. Do a
carefully controlled timed fuel burn at WOT at 7500-8000 MSL. The
computed
your fuel burn rate, multiply the Gallons/hour to turn it into pounds/hour
and then divided by 0.55 to get a fair estimate of your HP.
Best Regards
Ed Anderson
Chuck wrote:
Ed, Sorry for not responding sooner, but I wanted to try a few thing first.
I am still trying to find out why I am down on power. Since 1-1-2001 I have
tried:
1. Installed new engine because the old one was using too much oil.
2. Removed muffler and installed a temporary exhaust header with straight
thru "holey pipe"
3. Removed Performance prop and had it de-pitched, reinstalled.
None of these things made any real difference. At least I'm not using oil
anymore. All the new exhaust did was make it way noisier so I put my old
muffler back on. I now get 5100 RPM static and 5800 RPM WOT but still
getting 153 KTS top speed. I took your suggestion and measured fuel burn for
1 hour at 8000 feet WOT and used 8.5 gallons. By your formula, that works
out to about 95 HP. I am at 3000' MSL here, but I don't think that accounts
for that much difference from your burn of 14GPH static. I am working on a
new larger throttle body and maybe will make a new intake plenum as well. My
throttle body is now 2 1/8" ID. I am losing 1.3" MP. I removed the K&N air
filter and it made no difference, so maybe 2 1/8" is too small like Paul
told me at Copperstate.
I am also trying some intake cowling mods to try and reduce drag, but I need
to stop experimenting for a bit so I can be ready for a Long cross country
to Sun-N Fun! I hope to meet you there.
Chuck Dunlap
Great Chuck we can all get together there and put our collective minds together on your
problem. See you there.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org