Subject: Single rotor shaft drawing
From: Paul
Date: 3/27/2001, 10:13 AM


Francois,
         I started to build a single rotor rotary
engine.
I am ready to machine the eccentric shaft.

Did you make a drawing of the eccentric shaft that
you
machined or had machined or did you just do it
from
sketches?  I would like to get a copy of a drawing
if
one exists. Can you help out in any way?

Thank you.

Wally

Francois St-Germain wrote:

Hi Wally, Sorry I have not work on the shaft yet.
I will take a very precise mesurement of the section I
will remove (housing and intermediate housing),cut it
from the shaft and make a copy of the shaft end!
All the informations needed is already on the shaft
I will try to do it next week.
I keep you in touch!
Frank 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org