I know have 260 1/8" dia holes in a 36" length of 4' tubing.  One

for

each exhaust.  The fishtail is squeezed down to 1/4" slot.  So we will

see

if it lives when next I fly.

Ed

Are you beefing up your fish tails Ed?

Paul Lamar

I have not done so as yet, Paul.

    Not having any welding equipment, I just fashioned two more "expendable"
fishtails and stuck them on the end of 4 foot length of tubing.  That puts
them over twice the distance from the exhaust port as the previous set.
Will be interesting to see if they live any longer or not.

   When I get back from Sun & Fun I will see about getting some nicer
looking fishtails crafted and reinforced.  I was busy creating brackets to
hang the pipes from and getting other things ready for S&F.

   See attached photo of the cracks in the 2" 0.035 SS pipe.  The hole sizes
are 5/16" dia but apparently did little to dissipate the energy of the
exhaust pulse.

Ed

A fish tail is not a true fish tail unless the area of the slot is the same
as the area of the round pipe. Merely squishing the pipe does not meet 
this criteria. We need to make this clear so we all know what we are talking
about. If it is a true fish tail it is
supposed to reduce the noise all by itself. No holes needed. It does however
need to be beefed up to deal with the sonic induced vibrations.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org