"Perry J. Mick" wrote:
Paul wrote:
I made a few guesses here as to the static thrust.
One is 500 pounds for Tracy's current prop.
The other is 200 pounds for a really bad high pitch prop
optimized for cruise at 2100 RPM and 180 HP or perhaps Perry
Mick's ducted fan.
The thrust in theory drops off as speed builds but in actual
fact it probably increases at low speeds because the blades come out of stall.
In any event I allowed the thrust to degrade at the rate of one
pound per mph. Real results would probably show a shorter takeoff distance
for the 200 pound static thrust case because the thrust would probably
increase rather than decrease in this speed range.
Here are the takeoff distance results for the two cases and the program
used to calculate them. The 500 pound static thrust showed a take off
distance of about 500 feet and 65 mph. the 200 pound thrust case showed
about 1500 feet at 65 mph. The wing area used in these examples is a bit too
small for the RV because obviously the lift coef. is not that high at 65 mph.
1500 feet take off is more like most certified airplanes.
Interesting. I rotate at about the first taxiway exit (rwy 22 at MMV) at 80
knots (not 65 mph) which appears to be about a third of the length of the
runway including the extension on the 04 end, or about 2000 feet.
But I watch Cessna's takeoff, and they aren't rotating that much before the
spot that I rotate at. 1500 feet, like you say.
Perry Mick
Duckt N7XR
http://www.ductedfan.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org