"Rogers, Bob J." wrote:

Can anyone give me some suggestions on how to be sure that I get the crank
angle sensor properly reinstalled in the front cover hole on a 2nd
Generation (87-91) 13B rotary engine?  It appears that there is ample
opportunity to screw up the timing if not done correctly.

Do you have a shop manual? There are marks on the e-shaft pulley,
(use the leading mark), the pointer on the block, the base of the 
crank angle sensor housing and the driven gear. Align all four and install
the crank angle sensor. Page 155 86-91 Haynes manual.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org