Martin Orro wrote:

        Would there be a problem with making mounts which replace the
side spacers between Tracy's PSRU and the rear engine housing?  They
would be L-shaped with the short leg substituting the spacers and the
long leg mimicking Pauls extensions to the Barry mounts.  These could be
designed to extend to the Barry mounts either at the engine or PSRU.

                        Martin

That would work if properly designed. Do you have a sketch Martin?
Each one should pick up a minimum of two ten MM bolts.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org