Paul - I'm interested in what you mean by this. I'm rebuilding my 1990
NA engine with 1993 housings. Do the housings have qualities I should be
taking advantage of?
John McLaughlin
I just found out the 93 and later REW ports are larger than the earlier
engines.
Should get you more power. Are you changing just the rotor housings or the
end housings?
If just the rotor housings I don't think it will make much difference. The
bigger
intake ports are in the end housings of course.
I was planning on just using the rotor housings, although I have access to a
set of end housings for a good price. Given that the NA intake is a 6 port
design, how does it mate with the 4 port end housings? Would it require a
custom intake or is there something I'm missing?
The REW rotor housings do not have the exhaust diffusers found on my NA
housings. I'm assuming this is advantageous when it comes to porting the
engine. Do you think there are any problems I should watch out for?
John
They will mate fine John. Here is a picture of Tracy's new 3 rotor with the
REW large intake port endhousings. Neat thing about the rotary. You can more or
less mix and match parts. This engine was built up by Bruce Turrentine from mostly
93 and later 13B REW (two rotor) parts. Rotor housings fit four or six port engines
amd three rotor engines. Same goes for rotors and e-shafts.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org