Subject: Junk Yard Cars-Engines Years and type.
From: Paul
Date: 4/12/2001, 10:01 PM


They will mate fine John. Here is a picture of Tracy's new 3 rotor with
the
REW large intake port endhousings. Neat thing about the rotary. You can
more or
less mix and match parts. This engine was built up by Bruce Turrentine
from mostly
93 and later 13B REW (two rotor) parts. Rotor housings fit four or six
port engines
amd three rotor engines. Same goes for rotors and e-shafts.

You've piqued my curiosity, Paul. I've spend the last 45 minutes with my
poorly annotated Haynes manual, so I may have some misinformation - bear
with me.

It would seem that the intake port sizes, number and position differ from
engine year (series 4, 5 or 6) and turbo vs. NA. Obviously, the end housings
for a 6 port require a large runner to mate the intake manifold to the end
housing. The 93 end housings have huge ports, but from these very poor
pictures and diagrams, it would surprise me if NA intake would bolt up to
the 93 end housings. Besides the physical fit, there is dealing with the 6
port actuators, etc.


Surely, this would require a custom intake, right? Probably new fuel /
ignition control as well?

Yes a custom intake manifold is required. The stock manifolds, in their many variations,
are too high and too heavy for aircraft use. Tracy's EFI/ignition controller
is programmable and will adapt to a super or turbo charged engine be it six or
four ports. Tracy may have some six port intake manifold flanges left out of
a batch we had made and Leon is working on a four port manifold casting for the
earlier four port engines. Not the late REW engines yet. PL

If my ignorance is showing, please feel free to kill this note. I try to
glean knowledge from your list from the land of car bound masses.

thanks - john

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org