Subject: Leading coil ballast resistor failure
From: Paul
Date: 4/15/2001, 8:33 PM


Leon Promet wrote:

Hey Guys,

Why are you guys using ballast resistors on your coils?  Are you still
using a Kettering points system??


Things must be very different Downunder Leon.  Every 13B since 1986 up to
1991 has a ballast resistor on the leading coil (which is a double ended
coil firing both leading plugs).  The trailing coils do not have ballast
resistors and are independant (one per plug).

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

BTW at high RPM there is little difference in the current drain between
a inductive current interrupter system (Kettering) and a pulse type system. I 
assume, since Tracy is calling it a ballast resistor, the Mazda system is an 
inductive interrupter type. The opening mechanical points are merely replaced 
by a transistor that "turns off".

Am I correct about that Tracy? If that is the case the ballast resistor is there
to limit the saturated current flow through the coil at low RPM. Some after market 
CD pulse systems have you remove the resistor and use the coil as a simple pulse 
transformer as I recall. In that case current drain is proportional to RPM.

Paul Lamar 
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org