Jerry, in previous letter you statue, you have an kit for $200

whcich

include ...? And this kit could do ....... ?
I do not look on way how need to measure max. current when
flaps is overloaded. What I need is find a source to buy good

quality

servos with or without electronics/electromechanics.
Please describe what you kit do and where I could get what is not
included in the kit.
Thanks.
Vlad
N1UT - Velocity Elite, RG, Mazda 20B rotary, NA - engine

installation in

progress

http://www.N1UT.velocity-air.com

"Bass, Jerry" wrote:

The kit includes a PC board that should be located near the flap

actuator. A

control to be mounted on the instrument panel or someplace

convenient.

A

feedback device that must be connected to the flap lever. Mine is

near

the

actuator screw.

You need to provide a +12 v dc ground, and wiring between the

actuator

and

the PC board and drive motor.

Jerry Bass

It is better!
But still I ask you where I could look on specs and pictures.
Who is manufacturing actuator and board? Where I could purchase one?
Thanks.
Vlad

"Bass, Jerry" wrote:

Reply to Vlad.  I build the PC Board.  It drives 1.5 amp motors.  It needs
+12v and ground and wiring to the actuator on the pnl.  Do you want one?

Jerry Bass

Jerry it seems to me you are not getting all your email.

Paul Lamar

"Bass, Jerry" wrote:

I will try to find Pix's.  Then send them via this medium.  It seems to be
the only thing working well on my RV6A.  Every thing else, I have done
twice, it seems.

Jerry Bass

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org