Subject: Leading coil ballast resistor failure Take 2
From: Paul
Date: 4/16/2001, 12:59 AM

Leon Promet wrote:

snips.....

##
However, I definitely don't like this "wasted spark" idea of firing two
plugs with a single coil. Sure,  it's a budget solution for someone fitting
one of these engines to a car.  Lose the igniter on the twin pole leading
coil and you lose BOTH leading plugs,  accompanied by a considerable loss
of power.

##
The rotary has this in-built 2 plugs per cylinder.  Make the most of it!!
So where ever possible,  However,  I much prefer the 1 coil,  1 plug
philosophy,  and with a separate igniter for each coil. This is one of
those areas,  like stationary gears that it is not wise to be too
parsimonious.  It also allows you to do a power balance and check each plug
on run-up before taking off.  Think about it!!

 Other than this resistor they
seem to be very reliable.

snips...

Finn as well as the rest of us are using
an electronic method of firing the stock coils. Almost nobody is
using a distributor except perhaps Yvon Cournoyer.


##
Yeah, ...  that's sort of what I figured,  and therefore I was surprised to
hear the term "ballast resistor". However,  I had seen some pix of dizzies
on rotary aero engines,  and as I haven't seen under Finn's cowl,  I wasn't
privy to what he had!!  I will readily confess that I prematurely jumped to
conclusions, based on unfounded assumptions,  and apriori pre-suppositions
and prejudices!  just didn't even enter my mind that he was talking about
the resistor beneath the coil pack!!

##
Just the idle thoughts of an idle mind!  Anyway, your choice,  and your
decision, ... and your butts,  not mine.  You all should know what a
lunatic I am by now.  I harbour  some really strange and funny ideas that
lurk within the deep dark recesses of my convoluted cerebral hemispheres!!
 Cheers,

Best wishes and kindest regards,

Leon Promet
leon@promotorsport.com.au

What about the bell housing and intake manifolds Leon?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org