Subject: Leading coil ballast resistor failure
From: Paul
Date: 4/16/2001, 12:34 AM


Tracy wrote:

Things must be very different Downunder Leon.  Every 13B since 1986 up to
1991 has a ballast resistor on the leading coil (which is a double ended
coil firing both leading plugs).  The trailing coils do not have ballast
resistors and are independant (one per plug).


Paul wrote:

BTW at high RPM there is little difference in the current drain between
a inductive current interrupter system (Kettering) and a pulse type system. I
assume, since Tracy is calling it a ballast resistor, the Mazda system is an
inductive interrupter type. The opening mechanical points are merely replaced
by a transistor that "turns off".

Am I correct about that Tracy? If that is the case the ballast resistor is there
to limit the saturated current flow through the coil at low RPM. Some after market
CD pulse systems have you remove the resistor and use the coil as a simple pulse
transformer as I recall. In that case current drain is proportional to RPM.


I still have the original resistor in my leading coil, for 160 hours now.  Several
months ago I bought a high power resistor replacement, but have yet to install
it.  I think I will now that it has happened three times.  Strange that this failure
is unheard of in the car.  Especially if it is only a current limiting resistor at
low RPM.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

Yes. I too find that strange. You would think it dissipated less power at high
RPM.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org