Leon Promet wrote:
Hey Guys,
Why are you guys using ballast resistors on your coils? Are you still
using a Kettering points system?? SNIP
It's built into the leading coil assembly on the '86 RX-7, Leon.
Finn
Why buy new coils when you don't need too? A lot of people get the
stock coils when you buy the engine. Other than this resistor they
seem to be very reliable. Finn as well as the rest of us are using
an electronic method of firing the stock coils. Almost nobody is
using a distributor except perhaps Yvon Cournoyer.
Paul Lamar
Rino Lacombe wrote:
The problem seems to be an overheating of that resistor due to the constant high rpm
when use in an aircraft. A much higher current in that resistor of a longer period
of time at constant high speed. Much different than in a car.
Rino
All this presupposes we are dealing with a ballast resistor here. That may not be
true as ballast resistor are usually not needed with electronic ignition systems.
When voltage is first applied to an inductor it takes time for current to build up
in the series circuit. At low RPM the time between interruptions of voltage is long so
the current has plenty of time to build up to a high sustained value. This is the function
of a ballast resistor to limit that current, prevent overheating of the coil and
there fore power dissipation in the ballast resistor is a maximum. In the old days
you could notice this by touching the coil while the points were closed and the ignition
switch was on with the engine off. The coil was usually hot enough to burn your fingers.
At high RPM the current has barely enough time to build up to its maximum value so
therefore the average current in the resistor and power dissipation is less.
Power (heat) in the resistor equals the voltage drop across the resistor times the
average current in the resistor.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org