Subject: Leading coil ballast resistor failure
From: Paul
Date: 4/16/2001, 9:19 AM


Leon Promet wrote:

Hey Guys,

Why are you guys using ballast resistors on your coils?  Are you
still
using a Kettering points system??


Things must be very different Downunder Leon.  Every 13B since 1986 up
to
1991 has a ballast resistor on the leading coil (which is a double ended
coil firing both leading plugs).  The trailing coils do not have ballast
resistors and are independant (one per plug).

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


BTW at high RPM there is little difference in the current drain between
a inductive current interrupter system (Kettering) and a pulse type
system. I
assume, since Tracy is calling it a ballast resistor, the Mazda system is
an
inductive interrupter type. The opening mechanical points are merely
replaced
by a transistor that "turns off".

Am I correct about that Tracy? If that is the case the ballast resistor is
there
to limit the saturated current flow through the coil at low RPM. Some
after market
CD pulse systems have you remove the resistor and use the coil as a simple
pulse
transformer as I recall. In that case current drain is proportional to
RPM.

Paul Lamar


Correct Paul.  The Mazda leading coil has a very low resistance and
inductance in order to saturate the coil quickly enough to spark  both
rotors at high rpm.  Without the ballast resistor, current would be
unacceptably high when dwell time is high ( low rpm, mainly during cranking
when the ECU can't accurately control dwell).   The watt rating of the
ballast resistor is just too low for the constant high rpm we run.  Except
for starting, average current is highest at high rpm because dwell time (per
spark) is held constant at operational rpm. This is the only detail that is
different than when using points.  Probably more than most wanted to know.

To answer your previous question about how I'm feeling and let the rest of
the group know why you asked:
 I had too much fun and laughed too hard at Sun 'n Fun.  Managed to give
myself a hernia.  I'm feeling OK as long as I get help lifting those redrive
shipping crates and don't laugh too much.  I see the surgeon on Thursday to
schedule a repair.

BTW Paul, please change my email address to the one on this message as the
old one will go dead soon.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org