"Bass, Jerry" wrote:

Flap Servo Photo.

Everyone has asked for Photos of the Servo control. I found these in my
construction log,  for the RV6A. The Control handle is on the left, and the
drive is above the flap actuator on a PC board with a three point mount.  A
slide (venire) feedback rod attaches to the flap arm. I used a Flap Drive
screw from Van's which draws about 1 amp with load.  I have found chips that
will drive 1.8 amps, but cost a bit more.

Jerry Bass

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org