Ken Powell wrote:

Paul,
I can build these now that I have seen yours.  If you want to mail my
housings back along with 1 of the new PP valves I can duplicate this
but with the valve opening from the opposite dirrection.  I can get my
local machine shop to bore the housing now that I am a little better
educated on how this works.  I can calculate the port timing with a
degree wheel (I've been wanting to own a degree wheel anyway!).

Just looked at the drawing again - why can't they just be installed in
what would have been the upside down position?

Thanks,
Ken Powell

OK Ken. I was a bit overwhelmed with the responsibility of holing
the housings anyway :-) I'll ship everything back.
Send me your address with private email.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org