Subject: Removing the oil thermostat.
From: Paul
Date: 4/19/2001, 6:14 AM

"Bass, Jerry" wrote:

Yes, I tested it and it did not protrude very far. The Copper slug, has
scratches on it like it was sticking partly open or closed.  I blocked the
stem with 3/16" washers drilled out to clear the operation. I moved it 3/8".
Do you think that was too much?

Jerry Bass

I don't think it works that way. I think only the small spring loaded plunger
extends to plug the bypass hole when it gets hot. 

In any event remove the thermostat.
Get a pipe plug tap and plug the little bypass hole.
Attach a long vertical hose to the inlet side and fill the hose and cooler 
with oil. See if the oil will then run through the cooler freely.
I think it will.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org