The main reason I choose wide spaced mounts was to give
plenty of room around the engine for turbo's, mufflers
and alternators.
Lets say you have mounts that support 150 pounds per side due
to the weight of the engine. 300 pounds total. Lets also say the
mounts deflect 33% under this static weight. That leaves 66% of
the deflection of the mount to account for the pulsing torque
reaction of the prop. The mount will take a total load of 450
pounds to bottom out.
BTW the pulsing torque reaction of the prop
is why all our airplanes with the exception of Power Sport use
the biscuit type rubber mount in the horizontal position. The rotary
does not have the up and down and side to side vibrations of the
horizontal opposed piston engine.
If the mounts are one foot apart and the
torque from the prop is 400 ft pounds that means one mount will
see 400-150 or 250 pounds up. 55% of its possible deflection and
the other will bottom out with 550 pounds on it.
If on the other hand the distance between the mounts is two feet
that means one mount will see only 200-150 or 50 pounds up and the
other will see 200+150 or 350 pounds down or 63% of its max deflection
leaving room for torque vibration isolation. The torque pulse can be up
to twice this high depending on how well Tracy's torque isolator
works so I think you can see the problem.
This is a simplification to a certain extent because the rubber mounts
are non linear but the same kind of analysis can be made.
You could stiffen the close together mounts by using harder rubber but I suspect
that would make the high frequency vibration isolation worse.
Since thrust is shared by all three rubber mounts and is more or less a steady
force the rubber between the steel bushing and the motor plate is more
than enough to cope with the thrust force.
Most side by side airplanes use wide horizontal opposed aircraft engines so the
stock cowling are all pretty much the same width. That means there is plenty
of room in them for a 29 inch wide mount like shown in my Cruiser pictures.
Those of you with inline or tandem seating RV3 and RV4's that want to make narrow
cowls are on your own :-) The RV8 tandem and RV9 side by side use the wide
non-cheeked cowls. BTW there is no proof that a narrow cowl significantly enhances
the thrust. It is thought to do so but there appears to be no real world
data to support this contention.
Hopefully I will find out if my Cruiser is any smoother than the
rotary powered airplanes I have flown in so far.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org