Here is a picture of the 22001 Barry rubber bushing
installed on the nose gear. The bracket must be drilled out
with a 3/4 inch hole. I used a hole saw.

The static load rating on this bushing is 250 pounds. Far higher than any
shock absorber bushing. The next size up will give you up to 630
pounds static rating but you will have to sleeve the hole in the rubber
mount steel spacer with another smaller steel spacer 1/2 inch OD with a 3/8 ID.

Page 956 in the 105 Mcmaster Carr catalog. $5.50
Comes with snubbing washer.
Vibration Control Mounts in the index.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org