Here is a sketch and picture of my latest design for the 2nd gen front
motor mount. (rear in a tractor). The 2nd gen front cover does not have
the built in motor mount bosses.
The holes in the front cover extensions have not yet been drilled
as I need to grind the flange off the edge of the oil pan seen
at the left. This was made from a 2 by 3 by 1/4 inch thick angle
extrusion. A T extrusion would work better as then you could pick
up two of the oil pan bolts instead of only one.
The exact dimensions of the pan hole from the front cover extensions
was hard to determine accurately. I made a special bolt with
a center point and tapped the bracket on the bottom with a hammer
to mark it for the drawing and drilling the hole. I took a picture
of this little bolt if anyone is interested.
These cute little Barry rubber mounts are just great as you can get them in
a variety of sizes and stiffnesses. Very cheap too at around $5 each.
The 22001 comes with a free snubbing washer.
Paul Lamar
Paul,
I like this better than your previous design due to the dual bolt axes and
double shear bolts. Stronger and lighter than the other design.
Bill
Long EZ builder & pilot
BSME, MSME
Me too. Funny how your mind can work when you are asleep. :-)
BTW I am kind of thinking of going to the flyin in Kansas that Perry
is attending. Where is that and what town would I fly UAL or
South West Airlines to? Are you attending and is there another
rotary powered airplane besides Perry showing up? Perhaps
Tom Jordan will show with his supercharged 13B Big EZ.
Also while I have you at the computer. I tried finding some VW
thermostats in So Cal. Gene Berg did not answer the phone on
Friday so I tried Love Bug in Oxnard. No luck so far.
I want to test these for work by placing them in a pan of water
on a hot plate placed on a bathroom scale with a frame work
resisting expansion. Sketch for you if this is not clear.
I did find three different versions which means we can taylor
the cowl flap "servos".
Part # temp
111 119 159A 65-70C
043 119 159 80-85C
021 119 159 85C
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org