Subject: 20B Tangental exhaust system mockup
From: Paul
Date: 4/23/2001, 12:09 PM


VO wrote:

snips.........

Still do not know where I could find material (INCONNEL)
to make exhaust.

Vlad I think you can get Inconel tubing from Burns Stainless.
http://WWW.burnsstainless.com/


Simplicity of TES allow to use sheet metal instead tubing. So far,
I believe I need INCONNEL sheets instead tubing. Also I could do
most of TES at my hangar.

Also I found some references on to old research on exhaust
systems and specially on tubing. Russian aviation industry found
round tubes usually on +20db side in comparison with square tubes.
Any comments?

Vlad
N1UT

Brian Trube might check again at Boeing surplus in Seattle.
Other wise try any metal supplier such as http://WWW.twmetals.com/

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org