Subject: COZY: Re: Question for a "P" (of "A & P")
From: Paul
Date: 4/25/2001, 11:47 PM


The "no thrust bearings at all" is VERY wrong.  All aircraft engines I have seen
have a hydrodynamic thrust bearing at the very large prop bearing.   The
only issue
is whether a pusher aircraft needs a special engine.  At one time Continental
made a "pusher version" of the O-200, but has said that the std engine is OK
for pusher.  This has been proven to be true for all engines tried.   The prop
end main bearing has flanges front and rear, with a thrust flange machined on
the crank in all the cases I know of.  The front side of the first crank cheek
is polished at the bearing and serves as the thrust surface on the crank for
tractor loads.


I think I mis-phrased that.  Guess I was still asleep this morning.  Of course
the piston engine has a thrust bearing, it's just a lubricated surface.  I even
remember reading on another list why: because you have to split the case.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

BTW Perry if you want to do and end run around the weather and take the
southern route you can stay over at my place and land at Camarillo.
The weather from here due East is usually pretty good.
I can pick you up there.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org