Subject: 3mm seal controversy
From: Paul
Date: 4/27/2001, 8:41 AM


marc wiese wrote:
This was taken from www.kdrotary.com/services/prices
"There are a lot of options when it comes to rebuilding your engine.. if you
have any questions please ask .. We want you to make an informed decision
and be happy with your RX-7.
NOTE: we no longer offer 3mm modifications.."
What gives ??
Richard

[repost]
So during a rebuild (if done professionally) the
tolerances of these apex channels are "mic'ed" (measured with a micrometer)
and are normally out of spec. So instead of throwing the rotors out and
buying new ones (I don't even know how much they cost new... I guess around
a $500 each?) the rebuilder will take the old rotors and send them off to a
machine shop and have the apex channels machined out to just under 3mm. They
then (if they are professionals) use gapping slivers and files to get the
clearances as near to perfect as possible. Often times they will leave it a
little on the thin side which will pinch the seals slightly, but due to the
wear of the metal on metal contact, the pieces should wear into "spec". For
this reason a break in period is crucial (change your oil OFTEN).

What are the tolerances? How bad can they be to get? (flatness, concentricity,
surface finish, parallelism, etc.)

Are we talking like +/- one or two tenths or are we talking like 50 millionths? How
much did they charge for this service?


And if you have read down this far... I have a little tid bit for you...
When a ceramic seal shatters and imbeds itself into the rotor, no matter how
cool it looks or how tempted you might be to run your hand over it...
DON'T... You will bring back a bloody mess. :-)

Actually I am going to look for a ceramic knife to complement my Wustoff Trident
set. They work great and slice for a really long time before needing a diamond
hone.

I guess they cut human meat pretty good too... :-O

Blake

Blake check your computer clock and calendar.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org