Subject: Air cooled rotary engines
From: Paul
Date: 4/30/2001, 9:22 PM


Curtiss Wright experimented with air cooled rotary engines specifically
targeted for aviation use. The RC-90 shared the same geometry with the
RC-60,
except the housings were 50% wider (much like the 13B is 10mm wider than
the
12A). The RC-90 displaced 90 cu inches per rotor. I believe two and four
rotor engines were built. Norbye's book may have some photos. I don't
recall
the rating.

The air cooled rotor housings had a multitude of deep, thin,
closely-spaced
fins. By my recollection, I'd say they were perhaps three inches deep by
.090" thick with .090" spacing. There was a very high speed blower used
to
force cooling air through the fins. I am sure that passive cooling would
be
inadequate.

I don't know why in particular C-W gave up on the concept. It is true
that
the heat flux in a rotary (locally in the spark plug region) is far
higher
than in a piston engine, and that cooling is one of the bigger
challenges
even with liquid cooling. I'd have to assume that C-W concluded that the
liquid cooled engine was a better trade off all around, with more growth
potential.

Jon Lauter
Rotary Power Marine Corporation


 Mark Waldron wrote:

Seems like this would be an excellent application for a heat pipe (moving
heat using high speed vapor transport to a "cool" end, liquid recondenses
and moves back via capilarry action through a wick).  They move heat
hundreds of times more efficiently than copper (or other metals), and you
could increase the available surface area for heat disssipation at a
convenient location far from the engine.  No pumps, and no moving parts
except the vapor (which seldom breaks down!).

Mark


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org