Subject: oil to water exchanger
From: Paul
Date: 5/1/2001, 9:50 AM

Neal Scherm wrote:

What BTU capacity should a heat exchanger have to cool a turbo 13b? I was looking at Fluidyne's parrallel unit @ 65,000. They also make a 80,000 unit but it's huge. Seems like it would make a great cooler for the pusher type or a remote location install (i.e. c/g correction for a heavy motor).
Any comments?
Neal

Here is the heat balance for a rotary. One HP per hour is 2545 BTU/hour
Effective heat is HP out of the shaft so about the same HP goes
out the cooling system. If the engine is putting out 200 HP the
same HP is going out the cooling system. Typical more or
less plus or minus a few percent one way or the other for 
all intermittent combustion engines. About one third goes to the
oil unlike most piston engines.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

heat-balance-diag2.gif