Subject: oil to water exchanger
From: Paul
Date: 5/1/2001, 12:59 PM


Neal Scherm wrote:

What BTU capacity should a heat exchanger have to cool a turbo 13b? I was
looking at Fluidyne's parrallel unit @ 65,000. They also make a 80,000 unit
but it's huge. Seems like it would make a great cooler for the pusher type
or a remote location install (i.e. c/g correction for a heavy motor).


Al Gietzen wrote:

Neal;

On the rotary, about 7% of the total heat from the fuel burn goes into the
oil.  For operation at 200hp, fuel burn is about 30,000 Btu/min; and about
2150 Btu/min (129,000 Btu/hr) to the oil.  I would suggest that you can get
by with a design point of something less than that (maybe 80%), unless you
think it likely that you will have sustained operation at that power level.
For the typical NA 13B, designing for about 100,000 Btu/hr (150hp shaft
output) ought to be fine.

I have found that most oil-water heat exchangers are not designed for the
amount of oil flow, or the heat loads, from the rotary.  In addition to heat
rejection capability, check the pressure drop for a max flow of about 16
gpm.

Al

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org