Subject: MT Propeller performance & psru ratio
From: Paul
Date: 5/2/2001, 1:53 PM

"Ray Richardson Jr." wrote:

Powersport has been flying with the MT 3 blade electric prop
since last fall.  The MT is very smooth through all flight
speeds. Take-off roll aprox. 250 ft.,  sustained climb rate 2250'/ min.
Top true airspeed  212 at 3000'  with our unfinished cowl.

Best part of this prop is we can cruise at 190 mph INDICATED airspeed
at 2314 prop rpm and 5300 engine speed. This gives a very smooth
and quiet cruise. Note we should all remind other aircraft users
that 5300 engine rpm is only 1767 rotor rpm, this will help them
relate to our rotary engine longevity.

Our Powersport reduction drive is a 2.29 ratio. We use a 6200
engine rpm limit. We deliver 448 lbs/ft at 2400 prop rpm
215 hp at 6000 engine = 2620 prop rpm.

We have redone our cooling system over the winter, testing and
improving our coolant flow with a 1/3 increase, also doubled our
coolant flow rate to our oil to water special built heat exchanger.

We will next finish redoing our cowling including ducting our heat
exchanger. Paul has chastised us endlessly for not doing this earlier.
I will admit Paul will prove right on this point.

Then we will find out how fast this airplane will really go.

All 4 of our RV-8 customers have ordered the MT prop from us
Both of our Velocity customers have ordered MT props also.
We are a MT prop dealer.

Ray Richardson Jr.
Powersport

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org