Subject: flying 700 nautical miles to cma
From: Paul
Date: 5/6/2001, 11:50 AM

Well guys you will never guess what it was. Had Perry and me going for days.
Perry test flew the airplane a total of four times which is not easy at 
a controlled airport like Palm Springs. It would cool normally on
the ground even on a 100 degree F day. Then as soon as Perry got in the
air the engine would over heat and he would have to return for landing
some times waiting for your run of the mill Palm Springs Piper Cub to land. 
(Gulfstream VIII).

Broken tension bolt. Perry had the 35 pound flywheel in there which did
not even slow down. Just bent the bolt over at 90 degrees when it came out of
the hole and contacted the flywheel. Could have seized the engine if it had 
been an auto transmission flex plate. Best to drill the headsof those bolts 
and safety wire them. This is a well known problem with early necked down 
tension bolts. Racing Beat recommends coating them with RTV before 
installation to damp the vibratory modes.

Perry really scared himself on the last test flight.
 
Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-in-front-ductit.jpg

bent-bolt.jpg