Neal Scherm wrote:
Hey all.
The Fluidyne "series" type heat exchanger has a 65k BTU rating. The
water side pressure drop is .49psi @ 40gpm. The oil pressure drop is 5psi
@ 14gpm.
What would the effect be of putting one on the hot side and one on the
cold side of the Radiator?
Can the stock 13b oil pump handle the pressure drop of both coolers?
What pressure drops are being experienced in the oil to air coolers?
I really like the drag reduction these units offer. As well as
maintaining a more consistent oil and water temp.
regards,
Neal
No drag reduction!!!! You need a larger radiator with more drag. There is no,
nada, none net gain!!!!!.
Paul Lamar
Greg Richter wrote:
Tried the Aeroquip version oil/water exchanger and it was a no-go. The
idea that I think is behind this approach is to raise the temperature
gradient across the radiator you _do_ have exchanging heat with air. Great
idea, but our rotisseries are a little hot already leaving not much margin
for heating the coolant further. If you can make it work, let me
know. I'd love to get rid of the oil cooler!
-GR
Greg Richter can usually be found in the North Carolina mountains searching
for wild mushrooms, honey trees or small hydroelectric sites. Emails are
best served with an old Madeira or Armagnac which greatly increases the
chance of a speedy or useful reply.
Cozy N722 -- Mazda 13B
Turbo http://bluemtn.com/greg -or- http://bluemountainavionics.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org