Well guys you will never guess what it was. Had Perry and me going for
days.
Broken tension bolt. Perry had the 35 pound flywheel in there which did
not even slow down. Just bent the bolt over at 90 degrees when it
came out
of
the hole and contacted the flywheel.
Mike Wills wrote:
Paul,
Its still not clear to me how the broken tension bolt is related to an
overheating problem. Could you clarify this?
Mike Wills
We are not sure it is Mike. Could be a coincidence since we also found a leak
in the system at Palm Springs. In theory a broken tension bolt on the
hot side of the engine could allow the engine parts to deflect and leak
combustion gases into the cooling system. A combustion gas leak could overheat
the coolant and blow it out through the pressure cap. Perry was running
a 24 psi pressure cap. The engine would overflow the stock catch tank and
blow coolant out right after takeoff. This happened yet again after we found
the leak. By that time the rotor housing could have been damaged by
the earlier overheating. It is tough to trouble shoot 700 miles from
home with just a few tools.
I made two 250 mile round trips out to Palm Springs.
The first time I did not bring any tools or an engine hoist.
Here is a picture of Perry and his airplane in the Bob Hope Hangar
filled with Palm Springs Piper Cubs as we are getting ready to remove the
engine. Engine hoist in the back ground.
After this experience I am convinced we need some sort of emergency
back up cooling system. A good idea for any water cooled aircraft engine.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org