Ken Welter wrote:
Double stack the bearings.Put two gearings in with a .090 thrust
washer between this will cut the rpm in half. If you look up the
engineering data on the bearings you are using you are reaching the
outer limit on rpm.
Great idea. Good trick.
Do you really need it here Ken? The RPM difference here is 7500 - 2630 or
4870 RPM because input and output shaft rotate in the same direction
and in effect, the thrust bearing is pressed against the output shaft.
The planet carrier is the output shaft and the bearing holder is bolted
to the planet carrier.
On the other hand with the 2.17:1 thrust bearing such as Tracy's setup
the RPM is ~ 6000 RPM because one side of the thrust bearing is pressed
against the stationary PSRU housing.
Also, as an aside and a matter of interest the RPM difference between
input shaft and output shaft with the 2.17:1 ratio is effectively
6000 + 2765 = 8765 RPM.
Paul Lamar
"Bass, Jerry" wrote:
I do not think there is enough room for two bearings. The bearing rotates at
engine minus prop speed. as the bearing is on the sun to planet carrier.
Jerry Bass
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org